LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Infotainment System -- Model 3 >> Antenna - FM HD Radio >> Tuner - FM/HD - Remove and Replace >> Install

Tuner - FM/HD - Remove and Replace: Install

  1. Install the bolts that attach the tuner onto the body.

    10.1 N.m (7.4 ft-lbs) 

    G14748520Courtesy of TESLA, INC.
  2. Install the clips that attach the wiring harnesses onto the tuner.
    G14748521Courtesy of TESLA, INC.
  3. Connect the electrical connector into the rear of the tuner.
    G14748522Courtesy of TESLA, INC.
  4. Connect the electrical connectors into the front of the tuner.
    G14748523Courtesy of TESLA, INC.
  5. Connect the backlight electrical connector into the tuner.
    G14748524Courtesy of TESLA, INC.
  6. Install the RH side rail trim. See TRIM - SIDE RAIL - LH (REMOVE AND REPLACE) .
  7. Connect a laptop with Toolbox 3 to the vehicle.
  8. In Toolbox, type "Tuner" in the search field.
    NOTE: Make sure that "Actions" is selected, if not already.
  9. In Toolbox, click the play button next to the "PING-BASH-TUNER", and then select Run  .
  10. Disconnect the laptop from the vehicle.
scientia non olet · About LEMON Manuals