2nd Generation (after April 10, 2016) Removal

Correction Code 17530702 

1. Remove the underhood storage unit Underhood Storage Unit (Remove And Install) .
2. Remove the front fascia Fascia Assembly - Front (Remove And Install) .
3. Remove the bolts (x2) and clips (x16) that secure the radiator shroud, but do not remove the radiator shroud at this time.
4. Disconnect the exterior air temperature sensor, and set it aside.
5. Remove the radiator shroud.
6. Release the bolt that secures the horn bracket to the active center louver assembly (torque 5 N.m).
   NOTE: Do not release the nut that secure the horn to the bracket.

   Courtesy of TESLA, INC.

7. While tilting the radiator forward, remove the horn and bracket by maneuvering them out through the circular hole in the radiator duct assembly.