Sensor - Parking Distance - Outer - Rear - Remove And Replace: Removal
- Open the LH front door and lower the LH front window.
- Set the air suspension to the Very High , and then turn on Jack Mode .
- Remove the screw that attaches the rear fascia to the LH rear quarter panel (torque 1.5 N.m).
- Apply masking tape to the edge of the LH rear quarter panel that is adjacent to the rear fascia.
- Carefully pull the LH end of the rear fascia away from the vehicle so that the outer parking distance sensor can be accessed.
- Release the locking tab, and then disconnect the electrical harness from the parking distance sensor.
- Carefully release the tabs that attach the parking sensor to the fascia bracket, and then remove the sensor from the bracket.
Tip: If needed, use a pick or small flat head screwdriver to carefully release the bracket tabs.
NOTE: Make sure the sensor retainer ring is also removed. - If reusing the retainer ring, remove the retainer ring and inspect for damage.CAUTION: Do not reuse the ring if it is overly worn or damaged.