Brake Back Plate Removal and Installation: Installation
- Install brake back plate and rear wheel hub referring to REAR WHEEL HUB ASSEMBLY REMOVAL AND INSTALLATION (REAR DRUM BRAKE MODEL) .
- Install parking brake cable (1) to brake back plate.
Tightening torque
Parking cable cap nut (a): 11 N.m (1.1 kg-m, 8.0 lbf-ft)
- Install wheel cylinder and connect brake pipe flare nut, and then tighten wheel cylinder bolts and flare nut to specified torque referring to WHEEL CYLINDER REMOVAL AND INSTALLATION: DRUM .
- Install brake shoe referring to REAR BRAKE SHOE REMOVAL AND INSTALLATION .
- Install brake drum referring to REAR BRAKE DRUM REMOVAL AND INSTALLATION .
- Fill reservoir with brake fluid and bleed brake system. For bleeding operation referring to AIR BLEEDING OF BRAKE SYSTEM .
- Adjust parking brake cable referring to PARKING BRAKE INSPECTION AND ADJUSTMENT .
- Install rear wheel referring to WHEEL (WITH TIRE) REMOVAL AND INSTALLATION .
- Check to ensure that brake drum is free from dragging and proper braking is obtained. Perform brake test (foot brake and parking brake).