DTC Confirmation Procedure
NOTE:
- If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.
- Check that the following conditions are satisfied when using this procedure.
- 4.4°C (39.9°F) < IAT < 50°C (122°F)
- 4.4°C (39.9°F) < ECT < 45°C (113°F)
- BARO > 75 kPa (0.8 kgf/cm2 , 10.8 psi, 0.75 bar)
- Fuel level < 85%
- Warm up engine to normal operating temperature.
- Drive vehicle at 40 km/h (25 mile/h) for 15 min.
- Turn OFF ignition switch and leave for 6 hours.