Rear Disc Brake Pad Inspection
Reference: REAR DISC BRAKE PAD REMOVAL AND INSTALLATION
Check pad lining (1) for wear. When wear exceeds limit, replace with new one.
CAUTION:
If the brake pad lining is polished with sandpaper, abrading particles will be embedded in the lining and will damage the brake disc. Do not polish a rough pad lining with sandpaper. Replace the pad with a new one.
NOTE:
When pads are removed, visually inspect caliper for brake fluid leak. Correct leaky point, if any.
Rear disc brake pad thickness (lining thickness) "a"
Standard: 9.0 mm (0.354 in.)
Limit: 1.0 mm (0.039 in.)