Installation (Lower)

Install oil pan (lower) as follows:
1. Use scraper to remove old liquid gasket from mating surfaces.
  
  Fig 1: Removing Old Liquid Gasket From Mating Surfaces
  Courtesy of SUZUKI OF AMERICA CORP.
  - Also remove old liquid gasket from mating surface of oil pan (upper).
  - Remove old liquid gasket from the bolt holes and thread.
    CAUTION: Do not scratch or damage the mating surfaces when cleaning off old liquid gasket.
2. Apply a continuous bead of liquid gasket using Tool to the oil pan (lower) as shown in illustration.
  
  Fig 2: Applying Continuous Bead Of Liquid Gasket Using Tool To Oil Pan (Lower)
  Courtesy of SUZUKI OF AMERICA CORP.
  
  Tool number: WS39930000 (-)
  
  Use Genuine RTV Silicone Sealant or equivalent. Refer to RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS .
  
  CAUTION: Attaching should be done within 5 minutes after coating.
3. Install oil pan (lower).
  - Tighten oil pan (lower) bolts in numerical order as shown in illustration.
    
    Fig 3: Identifying Oil Pan (Lower) Bolts Tightening Sequence
    Courtesy of SUZUKI OF AMERICA CORP.
Install oil pan drain plug. Refer to OIL PAN AND OIL STRAINER: REMOVAL AND INSTALLATION .
After 30 minutes fill with engine oil and inspect for leaks. Refer to CHANGING ENGINE OIL .
CAUTION: Do not fill the engine with oil for at least 30 minutes after oil pan is installed.