Parking Brake Shoe: Removal and Installation: Removal
WARNING:
Clean the brakes with a vacuum dust collector to minimize the hazard of airborne particles or other materials.
NOTE:
Remove the rear disc rotor only with the parking brake lever completely disengaged.
- Remove the rear disc rotor. Refer to [REAR BRAKE CALIPER AND DISC ROTOR: REMOVAL AND INSTALLATION ]
- Remove the return springs.
- Remove the adjuster.
- Remove the retainers, anti-rattle pins and shoes.
- Remove the pin retainer, then disconnect the parking brake cable from the toggle lever.
- Remove the back plate. Refer to AXLE SHAFT: REMOVAL AND INSTALLATION (C200), or AXLE SHAFT: REMOVAL AND INSTALLATION (M226).