LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator RMZ-4 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Instrumentation/Driver Info./Horn >> Diagnostic Information and Procedures >> The Fuel Gauge Pointer Does Not Move >> Diagnosis Procedure

Diagnosis Procedure

DIAGNOSIS PROCEDURE CHART

Step Action YES NO
1  CHECK COMBINATION METER INPUT SIGNAL 
  1. Select "Meter / M&A" on SDT.
  2. Using "FUEL METER" of "Data list", compare the monitor value with the fuel gauge reading on the combination meter. Refer to [FUEL LEVEL SENSOR SIGNAL CIRCUIT CHECK ].

Does monitor value match fuel gauge reading? 		 GO TO 2 Replace combination meter. Refer to [COMBINATION METER: REMOVAL AND INSTALLATION ].
2  CHECK FUEL LEVEL SENSOR SIGNAL CIRCUIT 
Check the fuel level sensor signal circuit. Refer to [FUEL LEVEL SENSOR SIGNAL CIRCUIT CHECK ].
Is the inspection result normal? 		 GO TO 3 Repair harness or connector.
3  CHECK FUEL LEVEL SENSOR UNIT 
Perform a unit check for the fuel level sensor unit. Refer to [FUEL LEVEL SENSOR SIGNAL CIRCUIT CHECK ].
Is the inspection result normal? 		 GO TO 4 Replace fuel level sensor unit. Refer to [FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY: REMOVAL AND INSTALLATION ]
4  CHECK FLOAT INTERFERENCE 
Check that the float arm does not interfere or bind with any of the components in the fuel tank.
Is the inspection result normal? 		 Replace combination meter. Refer to [COMBINATION METER: REMOVAL AND INSTALLATION ]. Repair or replace malfunctioning parts.
scientia non olet · About LEMON Manuals