LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Engine General Information & Diagnosis - Qr25DE (4 Of 5) >> DTC P1572: ASCD Brake Switch >> Component Inspection >> ASCD Clutch Switch

ASCD Clutch Switch

  1. Turn ignition switch OFF.
  2. Disconnect ASCD clutch switch harness connector.
  3. Check continuity between ASCD clutch switch terminals 1 and 2 under the following conditions.
    Fig 1: Checking Continuity Between ASCD Clutch Switch Terminals 1 And 2
    G06444317Courtesy of SUZUKI OF AMERICA CORP.
    CONTINUITY CHART

    Condition Continuity
    Clutch pedal: Fully released Should exist
    Clutch pedal: Slightly depressed Should not exist

    If NG, adjust ASCD clutch switch installation, refer to [CLUTCH PEDAL: ON-VEHICLE INSPECTION AND ADJUSTMENT ], and perform step  3 again.

scientia non olet · About LEMON Manuals