LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Engine General Information & Diagnosis - Qr25DE (3 Of 5) >> DTC P0605: ECM >> Diagnosis Procedure

Diagnosis Procedure

DIAGNOSIS PROCEDURE CHART

Step Action YES NO
1  INSPECTION START 
  1. With SDT 
    1. Turn ignition switch ON.
    2. Select "DTC check" mode with SDT.
    3. Touch "Clear".
    4. Perform DTC Confirmation Procedure. See  [P0605 ECM ].
    5. Is the 1st trip DTC P0605 displayed again?
  2. With GST 
    1. Turn ignition switch ON.
    2. Select Service $04 with GST.
    3. Perform DTC Confirmation Procedure  . See [P0605 ECM ].
    4. Is the 1st trip DTC P0605 displayed again?

Yes or No 		 GO TO 2. INSPECTION END 
2  REPLACE ECM 
  1. Replace ECM.
  2. Perform initialization of immobilizer system and registration of all immobilizer system ignition key IDs. Refer to [ECM RE-COMMUNICATING FUNCTION: SPECIAL REPAIR REQUIREMENT ]
  3. Perform "VIN Registration" in VIN Registration .
  4. Perform "Accelerator Pedal Released Position Learning" in Accelerator Pedal Released Position Learning .
  5. Perform "Throttle Valve Closed Position Learning" in Throttle Valve Closed Position Learning .
  6. Perform "Idle Air Volume Learning" in Idle Air Volume Learning .
 INSPECTION END   
scientia non olet · About LEMON Manuals