LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System - Qr25DE >> Repair Instructions >> Water Outlet and Water Piping: Removal and Installation >> Removal

Water Outlet and Water Piping: Removal and Installation: Removal

  1. Drain engine coolant from the radiator. Refer to [Changing Engine Coolant ].
    CAUTION:
    • Perform this step when engine is cold.
    • Do not spill engine coolant on drive belts.
  2. Remove the air duct. Refer to AIR CLEANER AND AIR DUCT: EXPLODED VIEW .
  3. Disconnect radiator hose (upper) at water outlet side. Refer to [RADIATOR: EXPLODED VIEW ].
  4. Remove water outlet.
  5. Remove throttle body coolant hose at heater pipe.
  6. Remove heater core coolant hose at heater pipe.
  7. Remove oil cooler coolant hose at heater pipe.
  8. Remove oil level gauge and oil level gauge guide.
  9. Remove exhaust manifold heat shield.
  10. Remove heater pipe and O-ring.
    CAUTION: Do not reuse O-ring.
scientia non olet · About LEMON Manuals