LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Accessory Drive Belts >> Engine Mechanical - Qr25DE >> Repair Instructions >> Drive Belts: Removal and Installation >> Installation

Drive Belts: Removal and Installation: Installation

Installation is in the reverse order of removal.

WARNING:
  • Avoid placing hand in a location where pinching may occur if the holding tool accidentally comes off.
CAUTION:
  • Do not loosen the auto-tensioner pulley bolt. (Do not turn it counterclockwise.) If turned counterclockwise, the complete auto-tensioner must be replaced as a unit, including pulley.
  • Confirm belts are completely set on the pulleys.
  • Check that there is no engine oil or engine coolant on the drive belt or pulley grooves.
NOTE:
  • Turn crankshaft pulley clockwise several times to equalize tension between each pulley.
  • Confirm tension of drive belt indicator (fixed side) is within the allowable working range.
scientia non olet · About LEMON Manuals