LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Rear Brakes >> Repair instructions >> Rear Brake Pad: Removal and Installation >> Removal

Rear Brake Pad: Removal and Installation: Removal

  1. Remove the rear wheel and tire. Refer to [TIRE ROTATION ]
  2. Remove the master cylinder reservoir cap.
  3. Remove lower sliding pin bolt using power tool and swing the caliper body up to access the brake pads.
  4. Support the caliper body with a suitable wire to avoid pulling on the rear brake hose.
  5. Remove the rear inner and outer brake pads, shims and retainers from the torque member.
scientia non olet · About LEMON Manuals