LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Hood/Fenders/Doors >> Repair Instructions >> Hood: Fitting Adjustment >> Clearance And Surface Height Adjustment

Clearance And Surface Height Adjustment

  1. Remove the front grille. Refer to [FRONT GRILLE: REMOVAL AND INSTALLATION ]
  2. Loosen the hood lock assembly and adjust the rubber bumpers until the surface height of the hood becomes 1 mm (0.04 in) lower than the fender.
  3. Engage the hood striker and temporarily tighten.
  4. Check the lock and striker for looseness.
  5. Tighten the bolts to specification.
  6. Adjust the surface height of the hood according to the fitting standard dimension by rotating right and left rubber bumpers.
  7. Install the front grille. Refer to [FRONT GRILLE: REMOVAL AND INSTALLATION ]
scientia non olet · About LEMON Manuals