Low Beam And High Beam
CAUTION:
Do not tighten adjustment screw beyond a torque of 1.67 N.m (17 kg-cm, 14.8 in-lb) or damage may occur.
NOTE:
By regulation, no means for horizontal aim adjustment is provided from the factory; only vertical aim is adjustable.
- Turn headlamp low beam on.
- Use adjustment screw to perform aiming adjustment.
- Adjust beam pattern until cut-off line (top edge of illumination area) is positioned at same height off ground as bulb center (on H-line). Measure cut-off line within distance A on H-line. See AIMING CHART below.
- Basic illuminating area for adjustment should be within the range shown on the aiming chart. Adjust headlamps accordingly.