LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2010 >> SX4 Crossover, 4WD, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Rear Brakes (Disc) >> Repair Instructions >> Rear Disc Brake Caliper Disassembly and Reassembly >> Disassembly

Rear Disc Brake Caliper Disassembly and Reassembly: Disassembly

CAUTION: Clean around caliper with brake fluid before disassembly.
  1. Remove disc brake piston (1) by turning piston counterclockwise with special tool.
    CAUTION: Be careful not to damage inside (bore side) of cylinder.

    Special Tool 

    (A): 09945-16060 

    Fig 1: Removing Disc Brake Piston Using Special Tool
    G06868525Courtesy of SUZUKI OF AMERICA CORP.
  2. Remove cylinder boot and piston seal (1).
    CAUTION: Be careful not to damage inside (bore side) of cylinder.
    Fig 2: Removing Cylinder Boot And Piston Seal
    G06868526Courtesy of SUZUKI OF AMERICA CORP.
  3. Remove bleeder plug and cap from caliper.
  4. Remove return spring (1), parking nut (2), washer (3), lever (4) and shaft cover (5).
    Fig 3: Removing Return Spring, Parking Nut, Washer, Lever And Shaft Cover
    G06868527Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals