LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2008 >> XL7 Base, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation/Driver Info./Horn >> Diagnostic Information and Procedures >> DTC B2976 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect harness connector at the driver door latch assembly.
  2. Ignition ON, verify the scan tool Driver Door Ajar Sw. parameter is Door Closed.
    • If not the specified value, test the signal circuit terminal 4 for a short to ground. If the circuit tests normal, replace the BCM.
  3. If all circuit tests normal, test or replace the driver door latch assembly.
scientia non olet · About LEMON Manuals