Enabling Air Bag System
- Confirm that battery negative (-) cable is disconnected.
- Turn ignition switch to "LOCK" position and remove key.
- Connect yellow connector (1) of driver air bag (inflator) module by pushing connector till click is heard from it.
Courtesy of SUZUKI OF AMERICA CORP.
- Connect yellow connector (1) of passenger air bag (inflator) module by pushing connector till click is heard from it.
Courtesy of SUZUKI OF AMERICA CORP.
- Install driver and passenger side front pillar lower trim.
- Install "A/B" fuse to fuse box.
- Connect negative (-) cable at battery.
- Turn ignition switch to ON position and verify that "AIR BAG" warning light flashes 6 times and then turns OFF. If it does not operate as described, perform AIR BAG DIAGNOSTIC SYSTEM CHECK
.