1st/Reverse Brake and One-Way No. 2 Clutch Inspection

Reference: 1ST/REVERSE BRAKE AND ONE-WAY NO. 2 CLUTCH DISASSEMBLY AND REASSEMBLY 

1. Check that sliding surfaces of friction, separator and retaining plates are not worn or burnt. If necessary, replace with a new one.
   NOTE:

   • If friction plate lining is exfoliated, discolored or worn hardly, replace all friction plates.
   • Before assembling new friction plates, soak them in A/T fluid for at least two hours.
   Fig 1: Identifying Friction Plates

   Courtesy of SUZUKI OF AMERICA CORP.
2. Measure height of several 1st/reverse brake piston return spring including plate.

   1st/reverse brake piston return spring height 

   Standard: 19.55 mm (0.77 in.) 

   NOTE: Do not apply excessive force when measuring spring height or it is not measured accurately.
   Fig 2: Measuring Height Of Several 1st/Reverse Brake Piston Return Spring

   Courtesy of SUZUKI OF AMERICA CORP.