DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
- Clear DTC.
- Start engine and it up to normal operating temperature.
- Shift select lever to "D" range and hold it for 20 seconds or longer.
- Drive vehicle and increase vehicle speed to 40 km/h (25 mile/h) or more for longer than 15 seconds.
- Stop vehicle and turn ignition switch OFF.
- Repeat step 3 to 5.
- Check DTC, pending DTC and freeze frame data.