Clutch Release Margin "c"
WARNING: This page is about a different variant/trim than selected.
- Pull up parking brake fully and block wheels.
- Start engine and keep engine at idle with neutral gear position.
- Without clutch pedal (1) depressed, slightly push the shift lever to reverse position until transaxle emits gear contact noise. Do not shift the lever to reverse position.
- With emitting gear contact noise, be slow to depress clutch pedal (1), and at gear contact noise died position (release point) stop depressing.
- Measure distance between release point (4) and full stroke point (5) on clutch pedal (1) which is shown by "c" in the figure.
Clutch release margin
"c": 25 - 55 mm (0.98 - 2.17 in.)
- If "c" is not within specification, it is possible that air is trapped in this system. If suspected so, bleed air referring to AIR BLEEDING OF CLUTCH SYSTEM . Upon completion of above inspection, start engine and check clutch for proper operation.