LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2008 >> SX4 Crossover, FWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Clutch) >> Repair Instructions >> Clutch Master Cylinder Removal and Installation >> Removal

Clutch Master Cylinder Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Clean around brake master cylinder reservoir cap and take out fluid with syringe or such from brake master cylinder reservoir.
  2. Disconnect clutch fluid pipe (4) from clutch master cylinder (1) referring to CLUTCH FLUID PIPE REMOVAL AND INSTALLATION .
  3. Disconnect clutch reservoir hose (2).
  4. Remove push rod from clutch pedal, and then remove clutch master cylinder.
    Fig 1: Disconnecting Clutch Fluid Pipe (4) From Clutch Master Cylinder (1)
    G04848183Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals