Brake Back Plate Removal and Installation: Installation
- Install brake back plate (1) and rear wheel hub referring to REAR WHEEL HUB ASSEMBLY REMOVAL AND INSTALLATION (REAR DRUM BRAKE MODEL) .
- Install parking brake cable (1) to brake back plate.
Tightening torque
Parking cable cap nut a: 11 N.m (1.1 kg-m, 8.0 lb-ft)
- Install wheel cylinder and connect brake pipe flare nut, and then tighten wheel cylinder bolts and flare nut to specified torque referring to Wheel Cylinder Removal and Installation .
- Install brake shoe referring to Rear Brake Shoe Removal and Installation .
- Install brake drum referring to Rear Brake Drum Removal and Installation .
- Fill reservoir with brake fluid and bleed brake system. For bleeding operation refer to AIR BLEEDING OF BRAKE SYSTEM .
- Upon completion of all jobs, start engine and then depress brake pedal with about 300 N (30 kg, 66 lbs) load at least 3 times until adjuster actuator clicking sound from drum brake can not be heard so as to obtain proper drum-to-shoe clearance.
Adjust parking brake cable referring to PARKING BRAKE INSPECTION AND ADJUSTMENT .
- Install rear wheel referring to WHEEL (WITH TIRE) REMOVAL AND INSTALLATION .
- Check to ensure that brake drum is free from dragging and proper braking is obtained. Perform brake test. See PARKING BRAKE .