LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2008 >> SX4 Crossover, FWD, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Rear >> Disc >> Repair Instructions >> Rear Disc Brake Caliper Removal and Installation >> Removal

Rear Disc Brake Caliper Removal and Installation: Removal

  1. Hoist vehicle and remove rear wheel.
  2. Release parking brake lever.
  3. Remove clip (1).
    Fig 1: Identifying Clip
    G04847594Courtesy of SUZUKI OF AMERICA CORP.
  4. Loosen brake pipe flare nut (1) using by flare nut wrench.

    Then remove clip (2).

  5. Remove flexible hose joint bolt (3), and disconnect brake flexible hose (4) from brake caliper.
    Fig 2: Identifying Flexible Hose Joint Bolt
    G04847595Courtesy of SUZUKI OF AMERICA CORP.
  6. Remove caliper pin bolts.
  7. Remove caliper from brake caliper carrier.
  8. Disconnect parking brake cable (1) from lever (2) while rotating lever in direction of arrow.
    Fig 3: Identifying Parking Brake Cable (1) And Lever
    G04847596Courtesy of SUZUKI OF AMERICA CORP.
  9. Remove brake pads, slide pins and slide pin boots from brake caliper carrier.
  10. Remove brake caliper carrier (1) from torsion beam (2).
    Fig 4: Identifying Brake Caliper Carrier And Torsion Beam
    G04847597Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals