LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2008 >> SX4 Crossover, FWD, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Rear >> Disc >> Repair Instructions >> Rear Disc Brake Caliper Disassembly and Assembly >> Disassembly

Rear Disc Brake Caliper Disassembly and Assembly: Disassembly

CAUTION: Clean around caliper with brake fluid before disassembly.
  1. Remove disc brake piston (1) by turning piston counterclockwise with special tool.
    CAUTION: Be careful not to damage inside (bore side) of cylinder.

    Special Tool 

    (A): 09945-16060 

    Fig 1: Turning Piston With Special Tool
    G04847604Courtesy of SUZUKI OF AMERICA CORP.
  2. Remove cylinder boot and piston seal (1).
    CAUTION: Be careful not to damage inside (bore side) of cylinder.
    Fig 2: Removing Cylinder Boot And Piston Seal
    G04847605Courtesy of SUZUKI OF AMERICA CORP.
  3. Remove bleeder plug and cap from caliper.
  4. Remove return spring (1), parking nut (2), washer (3), lever (4) and shaft cover (5).
    Fig 3: Identifying Return Spring, Parking Nut, Washer, Lever And Shaft Cover
    G04847606Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals