Master Cylinder Reservoir Removal and Installation: Removal

Clean outside of reservoir and master cylinder.
Disconnect fluid level switch coupler (1) and clamp (3) from reservoir (2).

Fig 1: Identifying Fluid Level Switch Coupler, Clamp And Reservoir
Courtesy of SUZUKI OF AMERICA CORP.
Drain brake fluid in reservoir.
Disconnect clutch reservoir hose from reservoir (M/T model).
Remove reservoir connector pin (1) by using special tool and then reservoir.
Special Tool

(A): 09916-44310

Fig 2: Removing Reservoir Connector Pin
Courtesy of SUZUKI OF AMERICA CORP.