Clutch Master Cylinder Assembly Removal and Installation: Installation

WARNING: This page is about a different car, the 2007 Suzuki Reno, 2007 Suzuki Forenza, 2006 Suzuki Reno, and 2006 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.

Install the clutch master cylinder and clutch master cylinder nuts.
Tighten:

Tighten the clutch master cylinder nuts to 22 N.m (16 lb-ft).

Fig 1: Identifying Clutch Master Cylinder
Courtesy of SUZUKI OF AMERICA CORP.
Install the master cylinder pipe.

Fig 2: Identifying Master Cylinder Pipe
Courtesy of SUZUKI OF AMERICA CORP.
Connect the master cylinder hose.
Connect the hose clamp on the master cylinder.

Fig 3: Identifying Master Cylinder Hose
Courtesy of SUZUKI OF AMERICA CORP.
Install the push rod fixing pin and push rod.
Install the locking clip.
Bleed the air. Refer to Air Bleeding .
For 2006 Models, adjust the clutch pedal. Refer to Clutch Pedal Adjustment .
Fill the reservoir with clutch/brake fluid up to the proper level.

Fig 4: Identifying 2006 Locking Clip And Push Rod Fixing Pin
Courtesy of SUZUKI OF AMERICA CORP.