Conditions for Setting the DTC
WARNING: This page is about a different car, the 2006 Suzuki Reno and 2006 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.
No relevant DTCs are set.
(Common EVAP Enable Criteria)
- System voltage is between 10 and 16 V.
- Barometric Pressure (BARO) is greater than 72 kPa (10.4 psi).
- Engine soak time is greater than 720 minutes. Or, at startup IAT - ECT is less than 12 °C (53.6 °F).
- At start up, Engine Coolant Temperature (ECT) and Intake Air Temperature (IAT) are between 0 °C (32 °F) and 40 °C (104 °F).
- Startup IAT - IAT is less than 3 °C (5.4 °F).
- Purge enable time is less than pre-determined value based on startup ECT.
- Fuel level is between 6% and 93%.
- Engine run time is between 1 second and 300 seconds plus purge enable time.
(Small Leak Enable Criteria)
- When idling, engine speed is less than 1, 500 RPM, vehicle speed is less than 3 km/h, throttle position is less than 1%.
- When creeping, engine speed is less than 1, 500 RPM, vehicle speed is less than 6 km/h, throttle position is less than 2%, change in MAP is less than 10 kPa.