Conditions for Setting the DTC
WARNING: This page is about a different car, the 2006 Suzuki Reno and 2006 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.
(Common EVPD Enable Criteria)
- System voltage is between 10 and 16 V.
- Barometric Pressure (BARO) is greater than 72 kPa (10.4 psi).
- Engine soak time is greater than 720 minutes. Or, at startup IAT - ECT is less than 112 °C (233.6 °F).
- At start up, Engine Coolant Temperature (ECT) and Intake Air Temperature (IAT) are between 0 °C (32 °F) and 40 °C (104 °F).
- Startup IAT - IAT is less than 3 °C (37.4 °F).
- Purge enable time is less than pre-determined value based on startup ECT.
- Fuel level is between 6% and 93%.
- Engine run time is between 1 second and 360 seconds plus purge enable time.
(Small Leak Enable Criteria)
- When idling, engine speed is less than 1, 500 RPM, vehicle speed is less than 3 km/h, throttle position is less than 1%.
- When creeping, engine speed is less than 1, 500 RPM, vehicle speed is less than 6 km/h, throttle position is less than 2%, change in MAP is less than 5 kPa.