Brake Hose (Front) Removal and Installation: Installation
- Install the new disc brake hose to the caliper with new seal rings and the bolt.
Tighten:
Tighten the front disc brake hose-to-caliper bolt to 40 N.m (30 lb-ft).
- Slide the brake hose on the steering knuckle shaft "C" bracket.
- Connect the brake pipe line to the brake hose on the wheel housing bracket on each side of the vehicle.
Tighten:
Tighten the brake line to 16 N.m (12 lb-ft).
- Lower the vehicle.
- Bleed the brake system. Refer to Manual Bleeding the Brakes .
- Check the brake system for leaks.
See Fig 1.