LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2008 >> Reno Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Rear >> Repair Instructions >> Brake Pads Removal and Installation >> Removal

Brake Pads Removal and Installation: Removal

  1. Raise and suitably support the vehicle.
  2. Remove the rear wheels. Refer to WHEEL REMOVAL AND INSTALLATION .
  3. Remove the lower caliper guide pin bolt.
    Fig 1: Identifying Lower Caliper Guide Pin Bolt
    G04717038Courtesy of SUZUKI OF AMERICA CORP.
  4. Pivot the caliper upward.
  5. Remove the brake pads.
    Fig 2: Identifying Brake Pads
    G04717039Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals