LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2007 >> Reno Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Rear >> Repair Instructions >> Caliper Removal and Installation >> Installation

Caliper Removal and Installation: Installation

  1. Install the caliper with the mounting bolts.

    Tighten: 

    Tighten the caliper mounting bolts to 56 N.m (41 lb-ft).

    Fig 1: Identifying Caliper Mounting Bolts
    G04717043Courtesy of SUZUKI OF AMERICA CORP.
  2. Connect the brake hose with the bolt and ring seals.

    Tighten: 

    Tighten the brake hose inlet bolt and ring seals to 32 N.m (24 lb-ft).

  3. Install the rear wheels. Refer to WHEEL REMOVAL AND INSTALLATION .
  4. Lower the vehicle.
  5. Fill the master cylinder to the proper level with clean brake fluid.
  6. Bleed the caliper. Refer to MANUAL BLEEDING THE BRAKES .
    Fig 2: Identifying Caliper
    G04717042Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals