LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2007 >> Reno Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Rear >> Repair Instructions >> Brake Pads Inspection

Brake Pads Inspection

  1. Raise and suitably support the vehicle.
  2. Remove the rear wheels. Refer to WHEEL REMOVAL AND INSTALLATION .
  3. Visually check the brake shoe linings for minimum thickness and wear.
  4. Measure the thickness.
    NOTE: The minimum discard thickness of the brake shoe lining is 2 mm (0.08 in.).
  5. Install the shoes in axle sets only.
  6. Install the rear wheels. Refer to WHEEL REMOVAL AND INSTALLATION .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals