DTC Troubleshooting
WARNING: This page is about a different variant/trim than selected.
DTC TROUBLESHOOTING CHART
| Step | Action | YES | NO |
|---|---|---|---|
| 1 | Was "A/T System Check" performed? | Go to Step 2. | Go to A/T SYSTEM CHECK . |
| 2 | Is there DTC related to throttle position sensor (P0121 / P0122 / P0123)? | Go to DTC P0121: THROTTLE POSITION SENSOR CIRCUIT RANGE / PERFORMANCE, DTC P0122: THROTTLE POSITION SENSOR CIRCUIT LOW INPUT OR DTC P0123: THROTTLE POSITION SENSOR CIRCUIT HIGH . | Go to Step 3. |
| 3 | Check throttle position signal circuit for IG short
Is it 10 - 14 V? |
"PPL/WHT" circuit shorted to power circuit. | Go to Step 4. |
| 4 | Check throttle position signal circuit for open
Is continuity indicated? |
Go to Step 5. | "PPL/WHT" circuit open. |
| 5 | Check throttle position signal circuit for ground short
Is continuity indicated? |
"PPL/WHT" circuit shorted to ground. | Intermittent trouble or faulty TCM or ECM. Check for intermittent referring to INTERMITTENT AND POOR CONNECTION INSPECTION . If OK, substitute a known-good TCM or ECM and recheck. |