LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2006 >> Aerio Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission) >> Diagnostic Information and Procedures >> DTC P0717 (No. 37): Input / Turbine Speed Sensor Circuit No Signal >> DTC Troubleshooting

DTC Troubleshooting

WARNING: This page is about a different variant/trim than selected.
DTC TROUBLESHOOTING CHART

Step Action YES NO
1  Was "A/T System Check" performed?  Go to Step 2. Go to A/T SYSTEM CHECK .
2  Check input shaft speed sensor circuit 
  1. Disconnect TCM connectors with ignition switch OFF.
  2. Check for proper connection to input shaft speed sensor at "G07-5" and "G07-17" terminals.
  3. If OK, check resistance of sensor circuit.

Resistance of input shaft speed sensor circuit 
Between terminals "G07-5" and "G07-17" of disconnected harness side TCM connector: 344 - 516 Ω at 20 °C (68 °F)
Between terminal "G07-5"/"G07-17" of disconnected harness side TCM connector and ground: No continuity
Are check result satisfactory? 		 Go to Step 4. Go to Step 3.
3  Inspect input shaft speed sensor 
  1. Inspect input shaft speed sensor referring to INPUT SHAFT SPEED SENSOR INSPECTION .

Is result satisfactory? 		 "RED" or "GRN" circuit open or short. Replace input shaft speed sensor.
4  Check visually input shaft speed sensor and forward and direct clutches drum using mirror for the following 
  • No damage
  • No foreign material attached
  • Correct installation
G04591822

Are they in good condition? 		 Intermittent trouble or faulty TCM.
Check for intermittent referring to INTERMITTENT AND POOR CONNECTION INSPECTION .
If OK, substitute a known-good TCM and recheck.		 Clean, repair or replace.
scientia non olet · About LEMON Manuals