DTC Detecting Condition and Trouble Area
WARNING: This page is about a different variant/trim than selected.
DTC DETECTING CONDITION AND TROUBLE AREA CHART
| DTC detecting condition |
Trouble area |
No input shaft speed sensor signal is detected although output shaft speed sensor signals are detected under vehicle condition shown in the following.
- 1st gear and 7 km/h (5 mile/h) or more vehicle speed
or
- 2nd gear and 12 km/h (8 mile/h) or more vehicle speed
or
- 3rd gear and 17 km/h (11 mile/h) or more vehicle speed
or
- 4th gear and 24 km/h (15 mile/h) or more vehicle speed
|
- Input shaft speed sensor or its circuit malfunction.
- Improper input shaft speed sensor installation.
- Damaged forward and direct clutches drum.
- Foreign material attachment to sensor or drum.
- TCM
|