LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2006 >> Aerio Base, FWD, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation/Driver Info./Horn >> Diagnostic Information Procedure >> Audio System (If Equipped) Symptom Diagnosis >> Radio

Audio System (If Equipped) Symptom Diagnosis: Radio

AUDIO SYSTEM (IF EQUIPPED) SYMPTOM DIAGNOSIS

Condition Possible Cause Action
Poor radio reception  Out of service area (Poor location) -
Antenna faulty Replace antenna  .
Antenna amplifier faulty Replace antenna amplifier  .
Electrical part / system faulty Repair or replace electrical part / system referring to after-mentioned NOTE  .
Wiring and/or grounding faulty Repair circuit  .
Radio assembly faulty Replace radio assembly  .
Radio does not operate and speaker does not sound  Circuit fuse(s) blown Replace fuse(s) and check for short circuit  .
Wiring and/or grounding faulty Repair circuit  .
Radio assembly faulty Replace radio assembly  .
Radio does not operate, but speaker sound  Wiring and/or grounding faulty Repair circuit  .
Radio assembly faulty Replace radio assembly  .
Radio is operative, but all speakers does not sound  Wiring and/or grounding faulty Repair circuit  .
Radio assembly faulty Replace radio assembly  .
Individual speaker is noisy or inoperative  Speaker faulty Replace speaker  .
Wiring and/or grounding faulty Repair circuit  .
Radio assembly faulty Replace radio assembly  .
Sound quality is poor  Out of service area (Poor location) -
Speaker installed incorrectly Install correctly  .
Speaker faulty Replace speaker  .
Wiring and/or grounding faulty Repair circuit  .
Radio assembly faulty Replace radio assembly  .
NOTE: Electronic part / system with undiagnosed problem may cause electromagnetic interference. Electromagnetic interference condition may have poor radio reception. To test for presence of electromagnetic interference in part / system, perform the following procedures.
  1. Turn ignition switch to OFF.
  2. Systematically disconnect the electronic part / system connector(s) one at a time.
  3. Turn ignition switch to ON.
  4. Check any improvement in radio reception.