Fuel Level Sensor Inspection
- Check that resistance between terminals "a" and "b" of fuel level sensor changes with change of float position.
- Check resistance between terminals "a" and "b" at each float position in the following.
If the measured value is out of specification, replace fuel level sensor.
Fuel level sensor specifications
FUEL LEVEL SENSOR SPECIFICATIONS
| Float Position | Resistance (ohm) | |
|---|---|---|
| Full Upper "c" | 25.3 mm (1.00 in.) | 10+/-1 |
| Full Lower "d" | 191.2 mm (7.53 in.) | 130 +/-1 |