LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2005 >> Aerio S, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation/Driver Info./Horn >> Diagnostic Information and Procedures >> Audio System (If Equipped) Symptom Diagnosis >> Radio

Audio System (If Equipped) Symptom Diagnosis: Radio

AUDIO SYSTEM SYMPTOM DIAGNOSIS - RADIO

Condition Possible cause Correction / Reference Item
Poor radio reception  Out of service area (Poor location) -
Antenna faulty Replace antenna. 
Antenna amplifier faulty Replace antenna amplifier. 
Electrical part / system faulty Repair or replace electrical part / system referring to after-mentioned NOTE. 
Wiring and/or grounding faulty Repair circuit. 
Radio assembly faulty Replace radio assembly. 
Radio does not operate and speaker does not sound  Circuit fuse(s) blown Replace fuse(s) and check for short circuit. 
Wiring and/or grounding faulty Repair circuit. 
Radio assembly faulty Replace radio assembly. 
Radio does not operate, but speaker sound  Wiring and/or grounding faulty Repair circuit. 
Radio assembly faulty Replace radio assembly. 
Radio is operative, but all speakers does not sound  Wiring and/or grounding faulty Repair circuit. 
Radio assembly faulty Replace radio assembly. 
Individual speaker is noisy or inoperative  Speaker faulty Replace speaker. 
Wiring and/or grounding faulty Repair circuit. 
Radio assembly faulty Replace radio assembly. 
Sound quality is poor  Out of service area (Poor location) -
Speaker installed incorrectly Install correctly. 
Speaker faulty Replace speaker. 
Wiring and/or grounding faulty Repair circuit. 
Radio assembly faulty Replace radio assembly. 
NOTE: Electronic part / system with undiagnosed problem may cause electromagnetic interference. Electromagnetic interference condition may have poor radio reception. To test for presence of electromagnetic interference in part / system, perform the following procedures.
  1. Turn ignition switch to OFF.
  2. Systematically disconnect the electronic part / system connector(s) one at a time.
  3. Turn ignition switch to ON.
  4. Check any improvement in radio reception.