LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2004 >> XL-7 LX, 4WD, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Axle Bearings & Oil Seal (Grand VITARA, VITARA & XL-7) >> Removal & Installation (XL-7)

Removal & Installation (XL-7)

  1. Remove brake drum. See REAR DRUM . Drain rear differential fluid. Remove wheel speed sensor, and plug opening if vehicle is equipped with ABS. Remove wheel bearing retainer nuts from rear axle housing.
  2. Ensure clearance exists between rear wheel bearing retainer and parking brake shoe lever. If clearance does not exist, loosen parking brake cable lock nut. Using Wheel Hub Remover (09943-35512) and Slide Hammer (09942-15510 for 2003 models or 09942-15511 for 2004 models), remove rear axle shaft. Use caution when pulling out axle shaft to ensure brake backing plate does not come out with shaft and to prevent damage to upper and lower brake shoe struts and parking brake cable. Axle shafts are different lengths and cannot be interchanged. Left rear axle shaft is 27.6" (702.0 mm) long and right rear axle shaft is 30.3" (771.5 mm) long.
  3. If only rear axle shaft inner oil seal is being replaced, insert drift or screwdriver into axle shaft bearing retainer hole to hold backing plate in place. Remove rear axle shaft inner oil seal from axle housing. To replace rear axle bearings, continue to next step.
  4. Remove circlip from axle shaft. On models with ABS, grind wheel speed sensor rotor until thin enough to break with a chisel without damaging axle shaft. Remove wheel speed sensor rotor. On all models, grind wheel bearing retainer ring in 2 places until thin enough to break with a chisel without damaging axle shaft. Remove wheel bearing retainer ring. Using Bearing Holder (09921-57810) and Puller (09927-18411) remove wheel bearing and retainer from axle shaft. Remove old sealant from backing plate and axle hub mounting surfaces.
  5. To install, reverse removal procedure. Apply NEW sealant (99000-31110) to backing plate and axle hub mounting surfaces and backside of axle shaft inner oil seal before installation. Use NEW wheel bearing retainer ring and wheel speed sensor rotor on models with ABS. DO NOT damage wheel speed sensor rotor teeth or bearing retainer on models with ABS while pressing wheel speed sensor rotor onto axle shaft. Using proper bearing handle and installer, seat NEW inner oil seal in axle housing until it is seated on oil seal protector inside axle housing. Ensure axle shafts are installed in correct location.
scientia non olet · About LEMON Manuals