LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Heater And Ventilation) >> Repair Instructions >> Blower Motor Controller Removal and Installation >> Removal

Blower Motor Controller Removal and Installation: Removal

WARNING: This page is about a different car, the 2004 Suzuki XL-7 and 2004 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative (-) cable (2) at battery (1).
    Fig 1: Disconnecting Negative Cable At Battery
    G00757933Courtesy of SUZUKI OF AMERICA CORP.
  2. Disable air bag system.

    For H25 engine model, refer to AIR BAG RESTRAINT SYSTEMS .

    For H27 engine model, refer to AIR BAG RESTRAINT SYSTEMS .

  3. Open glove box, then remove screw and damper located on the right side of the glove box.
  4. Remove glove box.
  5. Remove ECM (PCM) with bracket from blower motor unit.
  6. Disconnect blower motor controller coupler.
  7. Remove blower motor controller (1) by loosening its fastening screw (2).
Fig 2: Removing Blower Motor Controller
G00757934Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals