Input Shaft Bearing Retainer & Oil Seal Disassembly & Assembly: Assembly
WARNING: This page is about a different car, the 2004 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.
Press-fit new oil seal (2) to bearing retainer (1) up to the specified position using special tool as shown in the figure. Apply grease to oil seal lip.
Grease: 99000-25010
Special tool
(A): 09913-75821
(B): 09924-84510-004
Oil seal installing position
"a": 11.2 - 12.2 mm (0.44 - 0.48 in.)