LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Diagnosis - A/T) >> Diagnostic Information and Procedures >> DTC P0974, P0977, P0986 (No. 21/23/48): Shift Solenoid "A, B & E" Control Circuit High >> Diagnostic Trouble Codes Confirmation Procedure

Diagnostic Trouble Codes Confirmation Procedure

WARNING: This page is about a different car, the 2004 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
  • Road test should be carried out with 2 persons, a driver and tester, on a level road.
  1. Connect scan tool to DLC with ignition switch OFF.
  2. Clear DTCs in TCM and ECM memories by using scan tool.
  3. Start engine and shift select lever to "D" range.
  4. Start vehicle and increase vehicle speed to 60 km/h (37 mile/h) in "D" range.
  5. Keep on driving in the speed for 20 seconds and decrease vehicle speed gradually.
  6. Stop vehicle.
  7. Check DTC, pending DTC and freeze-frame data.