LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Overhaul - A/T) >> Repair Instructions >> Pressure Control Solenoid Valves (Pressure Control Solenoid-A, Pressure Control Solenoid-B, Pressure Control Solenoid-C and TCC Solenoid Valve) >> Operation check >> Using Regulated DC Power Supply

Using Regulated DC Power Supply

WARNING: This page is about a different car, the 2004 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect pressure control solenoid valve (1) with regulated DC power supply (2) as shown in the figure.
  2. Turn regulated DC power supply switch ON, increase voltage of power supply keeping current within 1.0 A.
  3. Check that valve (3) moves gradually in arrow "A" direction as voltage increases.
  4. Check that valve (3) moves in arrow "B" direction as voltage decreases.
  5. Turn power supply switch OFF.
CAUTION: Do not feed current 1.0 A or more, or pressure control solenoid will be burned out.
Fig 1: Turning Power Supply Switch OFF
G00761563Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals