LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Clutches - M/T) >> Repair Instructions >> Clutch Master Cylinder Removal and Installation >> Removal

Clutch Master Cylinder Removal and Installation: Removal

WARNING: This page is about a different car, the 2004 Suzuki XL-7 and 2004 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean around reservoir cap and take out fluid with syringe or such.
  2. Remove clip (6) and push rod clevis pin (5).
  3. Disconnect fluid pipe (2) from master cylinder assembly (1).
    NOTE: Do not allow fluid to get on painted surfaces.
  4. Remove master cylinder attaching nut (3) and bolt (4).
  5. Remove master cylinder assembly (1) and gasket.
Fig 1: Removing Master Cylinder Attaching Nut
G00761798Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals