LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Air Bag Restraint Systems) >> Diagnostic Tests >> DTC B1016: Passenger-Side Air Bag Circuit Resistance Low >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2003 Suzuki XL-7 and 2003 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull top of glove box outward while depressing stops. Allow glove box to fall toward passenger seat. Disengage CPA clip and disconnect connector for passenger-side air bag module. See Figure.
  2. Connect STEERING WHEEL connector of Load Tool (09932-75010) to harness side of passenger-side air bag module connector. Turn ignition on. Using scan tool, retrieve DTC's. If DTC B1016 is current, go to next step. If DTC B1016 is not current, replace passenger-side air bag module. See PASSENGER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION.
  3. Turn ignition off. Disconnect SDM connector. See SENSING & DIAGNOSTIC MODULE (SDM)  under REMOVAL & INSTALLATION. Measure resistance between SDM connector terminals No. 7 (Yellow/Red wire) and No. 8 (Yellow wire). See Figure. If resistance is 1.4 ohms or more, substitute a known-good SDM and retest. If resistance is less than 1.4 ohms, repair short between Yellow/Red wire and Yellow wire. See WIRE REPAIR . Reconnect all components. Clear DTC's. Go to AIR BAG DIAGNOSTIC SYSTEM CHECK  under DIAGNOSTICS.
scientia non olet · About LEMON Manuals