LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Air Bag Restraint Systems) >> Removal & Installation >> Contact Coil & Combination Switch >> Removal

Contact Coil & Combination Switch: Removal

WARNING: This page is about a different car, the 2003 Suzuki Vitara and 2002 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, read air bag service precautions section. See AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Contact coil and combination switch are located under steering wheel in steering column.
  2. Disconnect negative battery cable. Remove steering wheel. See STEERING WHEEL  under REMOVAL & INSTALLATION. Remove hole cover and knee bolster panel. Remove screws and upper and lower steering column trim covers. Loosen clamp, remove band binding steering column and harness for contact coil and combination switch assembly.
  3. Disconnect contact coil and combination switch connectors. Remove contact coil and combination switch assembly from steering column.
    NOTE: New contact coil and combination switch assembly is supplied with contact coil set and held at center position with a lock pin and seal. Remove lock pin after installing contact coil and combination switch assembly to steering column.
scientia non olet · About LEMON Manuals