LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Air Bag Restraint Systems) >> Diagnostic Tests >> DTC 67: Driver-Side Seat Belt PRETENSIONER Short To Ground

DTC 67: Driver-Side Seat Belt PRETENSIONER Short To Ground

WARNING: This page is about a different car, the 2003 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Disconnect driver-side seat belt pretensioner connector D-26. Connect Load Resistor (MB991866) to Load Resistor Harness (MB991884). Connect Load Resistor Harness to connector D-26. Connect negative battery cable. Using scan tool erase, then retrieve DTC's. If DTC 67 is retrieved, go to next step. If DTC 67 is not retrieved, replace driver-side seat belt pretensioner. See SEAT BELT PRETENSIONER  under REMOVAL & INSTALLATION. Go to step  4.
  3. Disconnect SRS ECU connector C-114. Remove load resistor harness from driver-side seat belt pretensioner connector D-26. Measure continuity between ground and SRS ECU connector C-114, terminals No. 29 (Red/White wire) and No. 30 (Red wire). If continuity is not found in either circuit, erase, then retrieve DTC's. If DTC 67 is retrieved, replace SRS ECU. See SRS ELECTRONIC CONTROL UNIT (SRS ECU)  under REMOVAL & INSTALLATION. Go to next step. If continuity is found in either circuit, replace wire harness between SRS ECU and driver-side seat belt pretensioner. Go to next step.
  4. Reconnect all SRS components. Using scan tool, check for DTC's. If DTC 67 is retrieved, go to step  1. If DTC 67 is not retrieved, system is normal at this time. Intermittent condition may exist.
scientia non olet · About LEMON Manuals