DTC Confirmation Test (DTC P2227)
WARNING: This page is about a different car, the 2003 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition off, connect scan tool and turn ignition on. Using scan tool, clear DTCs. See CLEARING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM. Start engine and allow it to reach normal operating temperature.
- Drive vehicle with engine at 3000 RPM in 3rd gear (M/T) or 2 range (A/T). Release accelerator pedal and allow vehicle to coast (with vehicle in gear) for 5 seconds or more with engine speed of 1600-3000 RPM. Stop vehicle and allow engine to idle.
- Preform step 2 2 more times, for three times total. Using scan tool, check for current or pending DTC P2227. See RETRIEVING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM. If DTC resets, go to DIAGNOSIS & REPAIR PROCEDURE .